Items included with the DC04 SAN Director
Table 26
lists the items included with the standard shipment of the DC04 SAN Director.
Table 26 DC04 SAN Director shipping carton contents
The chassis includes:
•
CP blades (CP8)
•
Core switch blades (CR4S-8)
•
Port blades, application blades, and encryption blades (included based on customer specification)
•
Blade slot filler panels (for slots not filled by blades)
•
Port-side exhaust kit
•
Shipping bracket kit
•
WWN cards
•
WWN bezel (logo plate)
•
Power supplies
•
Blower assemblies
•
Vertical cable management fingers
•
Chassis door
The accessory kit includes:
•
HP StorageWorks product documentation
•
ESD grounding strap
•
RS-232 serial cable, with an adapter at one end to provide an RJ-45–style connector
IMPORTANT:
Order SFP transceivers separately. The DC04 SAN Director supports SWL, LWL, and ELWL transceivers.
See
http://www.hp.com
Installing the DC04 SAN Director in a rack
Air flows into the DC04 SAN Director through its non-port side and out through the exhaust vent on
the side of the unit. The port side exhaust kit is designed to route the airflow out the exhaust vents on
the port side of the unit while mounted in the equipment cabinet. This section provides instructions for
installing a DC04 SAN Director in a 48.26 cm (19 in.) EIA cabinet using the port-side exhaust kit for
cabinets with rail-to-rail depth of 68.58 to 78.74 cm (27 to 31 in.).
CAUTION:
Use safe lifting practices when moving the DC04 SAN Director. A fully populated DC04 SAN Director
(four FC8–48 port cards, 192 ports) weighs approximately 68 kg (150 lbs), and requires a hydraulic
or assisted lift to install.
Allow approximately one hour to unpack and install the DC04 SAN Director in a cabinet. The following
tools are required to install the rack mount kit:
•
Torque wrench with #2 Phillips screwdriver tip
128
DC04 SAN Director Installation
for more information on supported transceivers.