Adding A Static Route - NETGEAR GSM7252PS - ProSafe 52 Ports Gigabit Ethernet L2 Managed Stackable Switch Software Administration Manual

ProSafe 7000 Managed Switch Software Administration Manual, Release 8.0.3

Adding a Static Route

If your network switch has multiple routing interface that would allow different forwarding path to be taken
for reaching the same destination, it may make sense to create static route to force the packet to take certain
route (port) instead of the default route. The following procedure shows how to add static route to the switch
routing table.
CLI Command Procedure:
The following commands assume the switch has already defined a routing interface with network address of
10.10.10.0, and configured that all packets destined for network 10.10.100.0 take the path of routing port.
(FSM7328S) #show ip route
Total Number of Routes............................1
Network
Address
--------------- --------------- --------------- --------------- ---------------
10.10.10.0 255.255.255.0
To delete the static route, simply add "no" keyword in the front of the "ip route" command.
Web Interface Procedure
To configure a static route:
1. Go to Routing > Routing Table > Route Configuration to display the Route Configuration page.
Figure 3-7
3-8
Subnet
Mask Protocol
Local
v1.0, June 2010
Next Hop Next Hop
Intf IP Address
1/0/3 10.10.10.1
Port Routing