Assign Ports To Vlan3 - NETGEAR GSM7252PS - ProSafe 52 Ports Gigabit Ethernet L2 Managed Stackable Switch Software Administration Manual

ProSafe 7000 Managed Switch Software Administration Manual, Release 8.0.3
c. Click the Unit 1. The Ports display.
d. Click the gray box under port 1 and 2 until T displays. The T specifies that the egress packet is
tagged for the port.
e. Click Apply
2. Specify that only tagged frames will be accepted on port 1/0/1 and 1/0/2.
a. From the main menu, select Switching > VLAN> Advanced > Port PVID Configuration. A screen
similar to the following displays.
Figure 1-5
b. Under PVID Configuration, scroll down to interface 1/0/1 and select the checkbox for 1/0/1. Then
scroll down to the interface 1/0/2 and select the checkbox for 1/0/2.
c. Enter the following information in the PVID Configuration.
• Select VLAN Only in the Acceptable Frame Type polyhedron field.
• Enter 2 in the PVID(1 to 4093) field.
d. Click Apply to save the settings.

Assign Ports to VLAN3

This example shows how to assign the ports that will belong to VLAN 3, and to specify that untagged
frames will be accepted on port 1/0/4. Note that port 1/0/2 belongs to both VLANs and that port 1/0/1 can
never belong to VLAN 3.
Virtual LANs
v1.0, June 2010
1-5