Configure Isolated Vlans On A Layer 3 Switch By Using Acls - NETGEAR GSM7252PS - ProSafe 52 Ports Gigabit Ethernet L2 Managed Stackable Switch Software Administration Manual
7000 series managed switch administration guide for software version 8.0.3
Hide thumbs
Also See for GSM7252PS - ProSafe 52 Ports Gigabit Ethernet L2 Managed Stackable Switch:
- User manual (628 pages) ,
- Cli manual (788 pages) ,
- Hardware installation manual (39 pages)
Table of Contents
Advertisement
ProSafe 7000 Managed Switch Software Administration Manual, Release 8.0.3
b. Under Configure Routes, make the following selection and enter the following information:
•
Select Static in the Route Type field.
•
In the Network Address field, enter 192.168.30.0.
•
In the Subnet Mask field, enter 255.255.255.0.
•
In the Next Hop IP Address field, enter 192.168.200.1.
c.
Click Add.
Configure Isolated VLANs on a Layer 3 Switch by Using ACLs
Server
10.100.5.252
PC1
192.148.24.2
Figure 9-27
This example shows how to isolate VLANs on a Layer 3 switch by using ACLs. In this example, PC1 is in
VLAN 24, PC2 is in VLAN 48, and server is in VLAN 38. PC1 and PC2 are isolated by an ACL but can
both access the server. The example is shown as CLI commands and as a Web interface procedure.
Access Control Lists (ACLs)
Port 11/0/38
10.100.5.34
Port 1/0/24
192.148.24.1
v1.0, June 2010
Layer 3 Switch
Port 1/0/48
192.148.48.1
PC2
192.148.48.2
9-26
Advertisement
Table of Contents
