Add A Static Route - NETGEAR GSM7228PS Software Administration Manual

ProSafe 7000 Managed Switch Release 8.0.3
• The Preference field is optional. A value of 1 (highest) will be assigned by default if
not specified.
4. Click the Add button on the bottom of the screen. This creates the default route entry in the
routing table.

Add a Static Route

when the switch performas IP routing, it forwards the packet to the default route for a
destination that is not in the same subnet as the source address. However, you can set a
path (static route) that is different than the default route if you prefer. The following procedure
shows how to add a static route to the switch routing table.
CLI: Add a Static Route
The following commands assume the switch already has a defined a routing interface with a
network address of 10.10.10.0, and is configured so that all packets destined for network
10.10.100.0 take the path of routing port.
(FSM7328S) #show ip route
Total Number of Routes............................1
Network Subnet Next Hop Next Hop
AddressMaskProtocolIntfIP Address
--------------- --------------- --------------- --------------- ---------------
10.10.10.0 255.255.255.0 Local 1/0/3 10.10.10.1
To delete the static route, simply add "no" keyword in the front of the "ip route" command.
Chapter 4. Port Routing | 45