Linksys SPA921 - Cisco - IP Phone Installation And Configuration Manual page 89

Connecting the Equipment
Configuring Client Stations
STEP 4
SPA9000 Voice System Installation and Configuration Guide for Setup Wizard
As needed, configure each Line button (numbered Line 1, Line 2, Line 3, and so on,
depending on the phone model).
•
SLA: For a Shared Line Appearance, choose a station from the drop-down list.
Do not check any of the check boxes on the right side of the page. Refer to the
following illustration and description.
In this example, a station is configured with the name Sales2. Line 2 is
configured with a Shared Line Appearance for a station named Sales1. After
these settings are submitted, the button will display the name of the selected
station, Sales1. When an incoming call is directed to Sales1, both phones will
ring, and Line 2 on Sales2 will flash red. The user at Sales1 can answer the
call normally, or the user at Sales2 can answer the call by pressing the Line 2
button. If the call is answered and put on hold, it can be resumed from either
Sales1 or Sales2.
•
BLF: For a a Busy Lamp Field button, choose a station from the drop-down list,
and check the BLF box.
•
A Busy Lamp Field button is used to monitor calls on another station. The
button displays the name of the station that is being monitored. The LED
indicates the line status:
-
Red: Busy
-
Red Fast Blink: Ringing
-
Amber: Failed to subscribe (received 4xx response)
-
Amber Slow Blink: Undefined (may be no response to subscribe, or BLF
not specified)
•
To enable Call Pickup for the line, check the CP box. The user can press the
button to answer a call that is ringing on the other station.
Call Pickup is available only if BLF also is enabled.
NOTE
4
87