Linksys SPA921 - Cisco - IP Phone Installation And Configuration Manual page 58

Connecting the Equipment
Connecting and Configuring the Equipment (New Installation)
STEP 2
WARNING
STEP 3
STEP 4
SPA9000 Voice System Installation and Configuration Guide for Setup Wizard
From the Connection drop-down list, choose Static IP.
Do not guess at values for the fields on this page because your SPA400 devices will
not properly function without proper network settings. Refer to the information that
you collected before beginning the installation.
Enter the following information to configure a static IP address for the SPA400:
•
IP Address: Enter an IP address that is out of the scope of the LAN's DHCP
server, such as 192. 1 68.2. 1 92. Type a period (.) to move from one octet to the
next.
•
Subnet Mask: Enter the appropriate mask for your network.
•
Gateway: Enter the IP address of the network gateway.
•
Primary DNS: Enter the IP address of the DNS server for your network, which
may be the same as the gateway address, as in this example.
•
Secondary DNS server's IP addresses as appropriate for your network.
Click Next to display the Main Menu.
4
56