Linksys SPA921 - Cisco - IP Phone Installation And Configuration Manual page 62

Connecting the Equipment
Configuring the SPA9000
STEP 1
STEP 2
STEP 3
WARNING
SPA9000 Voice System Installation and Configuration Guide for Setup Wizard
Click OK to display the SPA9000 Network Installation - Static IP page.
From the Connection drop-down list, choose Static IP.
Enter the following information to configure the static IP address:
Do not guess at values for the fields on this page because your SPA9000 device
will not properly function without proper network settings. Refer to the information
that you collected before beginning the installation.
•
IP Address: Enter an IP address that is out of the scope of the LAN's DHCP
server. Type a period (.) to move from one octet to another.
•
Subnet Mask: Enter the appropriate subnet mask for your network.
•
Gateway: Enter the IP address of your network gateway.
•
Primary DNS: Enter the IP address of the DNS server for your network, which
may be the same as the gateway address, as in this example.
•
Secondary DNS server's IP addresses as appropriate for your network.
4
60