Linksys SPA921 - Cisco - IP Phone Installation And Configuration Manual page 86

Connecting the Equipment
Configuring Client Stations
STEP 4
STEP 5
SPA9000 Voice System Installation and Configuration Guide for Setup Wizard
If any SPA9x2 phone was previously configured for use with a
NOTE
SPA9000, reset the phone to the factory default settings. Press the
Setup button
message appears, press ok on the phone display to reset the phone.
If you are installing a WIP310 wireless phone, power on the WIP310 and configure
it for your wireless IP network, as described in the Cisco Wireless-G IP Phone
User Guide.
If any WIP310 was previously configured for use with a SPA9000
NOTE
device, reset the phone to the factory default settings. From the Home
screen, press the Select button to choose the Settings icon. Press the
Select button again to open the Settings menu. Use the Up or Down
arrow key to scroll to Factory Reset. Press the Select button. Under
Phone Reset, press the Right arrow key to choose Yes. Press the
Select button (check mark icon). When the confirmation message
appears, press the Select button (check mark icon).
Click Next to display the Configure Client Station page.
. Dial 14 for Factory Reset. When the confirmation
4
84