Upgrading Spa9000 Firmware (If Prompted) - Linksys SPA921 - Cisco - IP Phone Installation And Configuration Manual

Connecting the Equipment
Configuring the SPA9000
NOTE
STEP 1
STEP 2
STEP 3
SPA9000 Voice System Installation and Configuration Guide for Setup Wizard

Upgrading SPA9000 Firmware (If Prompted)

The Wizard verifies that the SPA9000 passes the minimum firmware version
requirement and will notify you in the event that out of date firmware is detected.
Complete this procedure if the following message appears:
required!
You must upgrade the SPA9000's firmware if the above message appears. If you
press cancel instead of selecting a valid version of firmware for the device, an error
message appears.
Click OK to navigate to the current version of SPA9000 firmware that you
downloaded.
On the Firmware Upgrade page, click Browse to select the spa9000-xxx.bin or
spa9000t-xxx.bin firmware file and click Open.
Click OK to begin the upgrade process. A series of messages appear as the
firmware is loaded and the device is upgraded.
When the process is completed, the Wizard displays the Configure SPA9000
Voice Services page.
4
Firmware upgrade is
62