IBM QS21 - BladeCenter - 0792 Service Manual page 94

Table 12. System firmware boot errors
Code Message
E5000 (USB) Media or drive not ready for
this blade.
E5010 (USB) No Media Found! Please
check for the drawer/inserted
media.
E5020 (USB) Unknown media format.
E5030 (USB) Device communication error Firmware cannot communicate
76
BladeCenter QS21 Type 0792: Problem Determination and Service Guide
Description
The media tray is not accessible
for boot.
Media is not inserted or the drawer
of the media tray is open.
The media is not recognized by
the firmware.
with the BladeCenter USB
devices.
Action
Verify that the media tray is
assigned to the blade and that the
media is configured correctly.
If this does not resolve the
problem, check the other blade
servers. If they cannot access the
media, there may be a problem
with the BladeCenter unit. See the
documentation that comes with the
BladeCenter unit for further
information.
Ensure that there is a bootable CD
or DVD in the tray and that the
drawer is closed.
Insert a suitable bootable CD.
This could be a firmware or
physical hardware problem.
Check:
The Advanced Management
v
Module for messages
v The system firmware image is
not corrupt. See "System
firmware update errors" on page
74 for more information about
possible errors and their
solution.
v Other blade servers within the
BladeCenter unit to see if they
have the problem. If they do,
the BladeCenter unit itself may
be the cause of the problem.
See the Problem Determination
and Service Guide for your
BladeCenter unit for more
information.
Finally, power down then reboot
the blade. If this does not help
resolve the problem, contact your
IBM service representative.