IBM QS21 - BladeCenter - 0792 Service Manual page 109

Problem determination and service guide
Hide thumbs Also See for QS21 - BladeCenter - 0792:
Table of Contents

Advertisement

Table 20. BMC firmware messages (continued)
Event
Cell/B.E. processor 0 Temp
above Shut-Off Temperature (
95°C)
Cell/B.E. processor 1 Temp
above Shut-Off Temperature (
95°C)
Temp above Shut-Off
Temperature (100°C)
Cell/B.E. companion chip 2
Temp above Shut-Off
Temperature (100°C)
Cell/B.E. Events
Processor Failure Cell/B.E.
processor 0 (Checkstop)
Processor Failure Cell/B.E.
processor 1 (Checkstop)
Failure Initializing Cell/B.E.
processor 0 or Cell/B.E.
companion chip 0
Failure Initializing Cell/B.E.
processor 1 or Cell/B.E.
companion chip 1
Severity
Message
Error
Processor 1 (BE0
Temp) critical fault.
Error
Processor 2 (BE1
Temp) critical fault.
Error
Processor 3 (SB1
Temp) critical fault.
Error
Processor 4 (SB2
Temp) critical fault.
Error
CPU 1 internal fault Reboot
Error
CPU 2 internal fault Reboot
CPU 1 Fault + "Init
Error
Failed #x", where x
is a number
representing the
error condition
Error
CPU 2 Fault
Automatic Action by
BMC
Power Off
The temperature of the
processor has reached a
critical level.
Power Off
The temperature of the
processor has reached a
critical level.
Power Off
The temperature of the
system board has reached
a critical level.
Power Off
The temperature of the
system board has reached
a critical level.
Power Off
Power Off
Chapter 5. Diagnostics and troubleshooting
Action required by
user
v Check that the
BladeCenter unit
cooling system is
operating correctly.
v Replace any
missing filler
blades in the
BladeCenter unit.
v Replace any
missing filler
blades in the
BladeCenter QS21
DIMM module
sockets.
v Check that other
blade servers are
operating within the
recommended
temperature range.
v Remove and
replace the blade
server, power on
and boot.
If problem persists,
please contact IBM
service.
There may be a
problem with the
system board. If
problem persists,
please contact IBM
service.
There may be a
problem with the
system board. If
problem persists,
please contact IBM
service.
Reboot. If the
problem persists, the
blade needs to be
replaced.
91

Advertisement

Table of Contents
loading

This manual is also suitable for:

Bladecenter qs21 type 0792

Table of Contents