Figure 23. Reinstalling the front bezel assembly
Complete the following steps to install the blade server front bezel assembly:
1. Read the safety information beginning on page vii and "Installation guidelines"
2. Connect the control panel cable to the control panel connector on the system
3. Carefully slide the front bezel assembly onto the blade server, as shown in
Note: Make sure that you do not pinch any cables when you reinstall the front
48
BladeCenter QS21 Type 0792: Problem Determination and Service Guide
Blade Cover
Blade-Cover
Release
Bezel-Assembly
Release
on page 29.
board assembly.
Figure 23, until it clicks into place.
bezel assembly.
Blade-Cover
Release
Bezel-Assembly
Release
Control-Panel
Cable
Bezel
Control-Panel
Connector