Removing The Front Bezel - IBM 8480 - Eserver xSeries 205 Maintenance And Troubleshooting Manual

Removing the front bezel

The following illustration shows how to remove the bezel from the server.
Note: The illustrations in this document might differ slightly from your hardware.
Do the following to remove the bezel:
1. Review the information in "System reliability considerations" on page 33.
2. Turn off the server and peripheral devices and disconnect all power cords and
3. Remove the side cover (see "Removing the side cover" on page 40).
4. Press the bezel-release latch at the top of the server to disconnect the top of
5. Release the two tabs at the top edge of the bezel and pull the top of the bezel
6. Pull the bezel up to release the two tabs at the bottom edge of the bezel. Store
68
IBM xSeries 205 Type 8480: Hardware Maintenance Manual and Troubleshooting Guide
then all external cables.
the bezel from the server.
slightly away from the server.
the bezel in a safe place.