IBM 8480 - Eserver xSeries 205 Maintenance And Troubleshooting Manual page 66

Attention:
v When you handle static-sensitive devices, take precautions to avoid damage
v To maintain proper system cooling, do not operate the server for more than 10
Complete the following steps to install a hot-swap hard disk drive in bay 5, 6, or 7.
Note: You do not have to turn off the server to install hot-swap hard disk drives in
1. Read the information in "Preinstallation steps" on page 49.
2. Remove the filler panel from one of the empty hot-swap bays by inserting your
3. Install the hard disk in the hot-swap bay:
4. If you have other options to install or remove, do so now.
56
IBM xSeries 205 Type 8480: Hardware Maintenance Manual and Troubleshooting Guide
from static electricity. For details on handling these devices, see "Handling
static-sensitive devices" on page 37.
minutes without either a drive or a filler panel installed in each bay.
these bays.
finger into the depression at the left side of the filler panel and pulling it away
from the server.
a. Ensure that the tray handle is open (that is, perpendicular to the drive).
b. Align the drive-tray assembly with the guide rails in the bay.
c. Gently push the drive-tray assembly into the bay until the drive stops.
d. Push the tray handle to the closed (locked) position.
e. Check the hard disk drive status LED to verify that the hard disk drive is
operating properly.
If the amber disk drive status LED for the drive is lit continuously, that
individual drive is faulty and needs to be replaced. If the green hard disk
drive activity LED is flashing, the drive is being accessed.
Note: If your server has a RAID adapter, you might need to reconfigure your
disk arrays after installing hard disk drives. See the information that
comes with your RAID adapter.
Filler panel
Drive tray
assembly
Drive tray handle
(in open position)