Moving the stabilizing feet
The four feet on the bottom of the server provide additional stability when the feet
are placed in the stabilizing position.
Complete the following steps to place the feet in the stabilizing position:
1. Place the server on its side.
2. Locate the release tab inside the foot; then, lift up on the tab.
3. Rotate the foot inward to the unlocked position; then, remove the foot from the
38
IBM xSeries 205 Type 8480: Hardware Maintenance Manual and Troubleshooting Guide
Note: The following illustration shows the rear feet located on the bottom rear
of the server.
Release tab
Feet (unlocked position)
Release tab
server.