Table of Contents
Advertisement
Removing the blade-server front bezel assembly
Before you can replace a defective system board assembly or blade server front
bezel assembly, you must first remove the blade server front bezel assembly.
Figure 23 shows how to remove the front bezel assembly from a blade server.
Figure 23. Removing the front bezel assembly
Complete the following steps to remove the front bezel assembly:
1. Read the safety information beginning on page vii and "Installation guidelines"
2. Open the blade server cover.
3. Carefully disconnect the control panel cable from the control panel connector.
4. Press the front bezel release on both sides of the system board and pull the
5. Store the front bezel assembly in a safe place.
Replacing the battery
IBM has designed this product with your safety in mind. The lithium battery must be
handled correctly to avoid possible danger. If you replace the battery, you must
adhere to the following instructions.
Note: In the U. S., call 1-800-IBM-4333 for information about battery disposal.
If you replace the original lithium battery with a heavy-metal battery or a battery with
heavy-metal components, be aware of the following environmental consideration.
Batteries and accumulators that contain heavy metals must not be disposed of with
normal domestic waste. They will be taken back free of charge by the manufacturer,
distributor, or representative, to be recycled or disposed of in a proper manner.
Blade Cover
Blade-Cover
Release
Bezel-Assembly
Release
on page 19.
front bezel assembly away from the blade server.
Blade-Cover
Release
Bezel-Assembly
Release
Control-Panel
Cable
Bezel
Control-Panel
Connector
Chapter 4. Installing and removing replaceable units
31
Advertisement
Table of Contents
