Hot-Swap Backplane - IBM 8480 - Eserver xSeries 205 Maintenance And Troubleshooting Manual

10. Place a screwdriver against the bottom release latch of the power button and
11. Gently pinch together the upper release latches and slide the latches through

Hot-swap backplane

Note:
To remove the hot-swap backplane, complete the following steps:
1. Turn off the server, if it is on.
2. Unplug the server.
3. Remove the front bezel. See "Removing the front bezel" on page 68.
4. Remove the side cover. See "Removing the side cover" on page 40.
5. Remove the support-bracket assembly. See "Removing the side cover" on page
6. Remove any hard disk drives or drive fillers from the drives.
7. Disconnect the hard disk drive cables that connect to the system board.
8. Swing the cage out.
9. Slide the backplane out of the cage.
70
IBM xSeries 205 Type 8480: Hardware Maintenance Manual and Troubleshooting Guide
9. Disconnect the cable of the power button from the system board.
gently press upward and slide the latch through the aperture.
the aperture and remove the power button.
v Read "Safety information" on page 119.
v Read "System reliability considerations" on page 33.
40.