Installing A Drive In Bay 1, 2, 3, Or 4 - IBM 8480 - Eserver xSeries 205 Maintenance And Troubleshooting Manual

v You must also set the SCSI ID for any SCSI device that you install in your server.

Installing a drive in bay 1, 2, 3, or 4

Do the following to install a drive in bay 1, 2, 3, or 4:
Attention: When handling static-sensitive devices, take precautions to avoid
damage from static electricity. For details on handling these devices, see "Handling
static-sensitive devices" on page 37.
Each SCSI device has its own methods and considerations for setting the SCSI
ID. See the instructions that come with the SCSI device for details about setting
the SCSI ID for the SCSI device.
1. Read the information in "Preinstallation steps" on page 49.
2. Turn off the server and attached devices and disconnect the external cables
and power cords.
3. Remove the side cover. See "Removing the side cover" on page 40 for details.
4. Remove the frame-support bracket. See "Removing the frame-support bracket"
on page 41.
5. Use a screwdriver to pry the filler panel and EMC shield away from the server.
Note: If you are installing a drive that contains a laser, observe the following
safety precaution.
Statement 3
CAUTION:
When laser products (such as CD-ROMs, DVD-ROM drives, fiber optic devices, or
transmitters) are installed, note the following:
v Do not remove the covers. Removing the covers of the laser product could result in
exposure to hazardous laser radiation. There are no serviceable parts inside the
device.
v Use of controls or adjustments or performance of procedures other than those
specified herein might result in hazardous radiation exposure.
DANGER
Some laser products contain an embedded Class 3A or Class 3B laser diode. Note
the following:
Laser radiation when open. Do not stare into the beam, do not view directly with
optical instruments, and avoid direct exposure to the beam.
6. Touch the static-protective package containing the drive to any unpainted metal
surface on the server; then, remove the drive from the package and place it on
a static-protective surface.
7. Set any jumpers or switches on the drive according to the documentation that
comes with the drive.
Chapter 4. Installing options
51