Rear fan
Note:
To remove the rear fan, complete the following steps:
10. Use needle-nosed pliers to pull the extensions through the apertures.
11. Reconnect cables.
74
IBM xSeries 205 Type 8480: Hardware Maintenance Manual and Troubleshooting Guide
v Read "Safety information" on page 119.
v Read "System reliability considerations" on page 33.
1. Turn off the server, if it is on.
2. Unplug the server.
3. Remove the cover. See "Removing the side cover" on page 40.
4. Remove the support-bracket assembly. See "Removing the side cover" on
page 40.
5. Remove the fan cable from the system board.
6. Use side cutters to sever the four rubber extensions on the outside of the
server.
7. Gently pry the fan away from the server and lift it up and out.
8. To install the new fan assembly, place the fan in position at the rear of the
server.
9. Guide the rubber extensions through the apertures.
Rubber
extensions
Rear
Fan