Removing The Blade-Server Front Bezel Assembly - IBM QS22 - BladeCenter - 0793 Service Manual

Cover pins
Figure 7. Removing the expansion unit
Complete the following steps to remove BladeCenter PCI Express I/O Expansion
Unit:
1. Read the safety information beginning on page vii and "Installation guidelines"
2. Carefully place the blade server on a flat, static-protective surface, with the
3. Press the blue blade cover release on each side of the blade server and lift the
4. To remove the expansion unit, carefully lift it from the cover pins and set it

Removing the blade-server front bezel assembly

Before you can add, remove, or replace system memory DIMM modules, replace a
defective system board assembly, or replace the blade server front bezel assembly,
you must first remove the blade server front bezel assembly.
Cover release
on page 29.
expansion unit side facing up.
expansion unit (see Figure 7).
aside.
Cover release
Chapter 4. Installing and removing replaceable units
33