Server Setup - Cisco AIR-LAP1252AG-A-K9 - Aironet 1252AG - Wireless Access Point Software Configuration Manual

Server Setup

Note
Note
Maximum Multicast Packets/Second
Server Setup
Note
Cisco Aironet 1200 Series Access Point Software Configuration Guide
3-48
For most configurations, you should leave Default Multicast Address Filter set to
Allowed. If you intend to set it to Disallowed, add the broadcast MAC address
(ffffffffffff) to the list of allowed addresses on the Address Filters page before
changing the setting to prevent being locked out of the access point.
If you plan to discard traffic to all MAC addresses except those you specify (the
Disallowed setting), be sure to enter your own MAC address as allowed on the
Address Filters page to prevent being locked out of the access point.
Use this setting to control the number of multicast packets that can pass through
the Ethernet port each second. If you enter 0, the access point passes an unlimited
number of multicast packets. If you enter a number other than 0, the device passes
only that number of multicast packets per second.
This section describes how to configure the server to support access point
features. You use separate management system pages to enter server settings. The
server setup pages are described in the following sections:
Entering Time Server Settings, page 3-49
•
• Entering Boot Server Settings, page 3-51
Entering Web Server Settings and Setting Up Access Point Help, page 3-55
•
Entering Name Server Settings, page 3-58
•
Entering FTP Settings, page 3-60
•
See the "Enabling EAP on the Access Point" section on page 4-20
on setting up the authentication server.
Chapter 3 Configuration
for instructions
OL-2159-03