Setting The Display Options; Using Station Pages - Cisco AIR-LAP1252AG-A-K9 - Aironet 1252AG - Wireless Access Point Software Configuration Manual

Chapter 5 Network Management

Setting the Display Options

Using Station Pages

OL-2159-03
You use the display options to select the device types to be listed in the table. The
default selections list only the access point and any devices with which it is
associated. To change the selections, click a display option and then click Apply.
To modify the table further, click additional display filters, which is a link to the
Association Table Filters page. You use the Association Table Filters page to
select the columns of information that appear in the Association Table and the
order in which devices are listed.
For more information on customizing the Association Table display, read the
"Association Table Display Setup" section on page
Click a device's MAC address in the Association Table's MAC Addr. column to
display a Station page for the device.
Station pages provide an overview of a network device's status and data traffic
history. The information on a Station page depends on the device type; a Station
page for an access point, for example, contains different information than the
Station page for a PC card client adapter.
You can also use the Station page to perform pings and link tests for network
devices. Figure 5-2 shows a sample Station page for a PC card client adapter.
Cisco Aironet 1200 Series Access Point Software Configuration Guide
Using the Association Table
3-64.
5-3