Cisco AIR-LAP1252AG-A-K9 - Aironet 1252AG - Wireless Access Point Software Configuration Manual page 260

Checking Basic Settings
Table 9-4
Firmware Version
PC/PCI cards 4.23
PC/PCI cards 4.25 and later
WGB34x/352 8.58
WGB34x/352 8.61 or later
AP34x/35x 11.05 and earlier
AP34x/35x 11.06 and later
BR352 11.06 and later
1. Functionality in Draft 10 is equivalent to the functionality in Draft 11, the
2. The default draft setting in access point and bridge firmware version 11.06
Draft standard 8 is the default setting in firmware version 11.05 and earlier, and
Note
it might remain in effect when you upgrade the firmware to version 11.06 or later.
Check the setting on the Authenticator Configuration page in the management
system to make sure the best draft standard for your network is selected.
Use the Authenticator Configuration page to select the draft of the 802.1x
protocol the access point's radio should use. Follow these steps to set the draft for
your access point:
Browse to the Authenticator Configuration page in the access point management
Step 1
system.
a.
b.
c.
Cisco Aironet 1200 Series Access Point Software Configuration Guide
9-42
802.1x Protocol Drafts and Compliant Client Firmware (continued)
1
ratified draft of the 802.1X standard.
and later is Draft 10.
On the Summary Status page, click Setup.
On the Setup page, click Security.
On the Security Setup page, click Authentication Server.
Chapter 9
Draft 7 Draft 8
—
—
—
—
—
2
—
—
Diagnostics and Troubleshooting
Draft
1
10
x —
— x
x —
— x
x —
x x
x x
OL-2159-03