Chapter 3
Configuration
File Transfer Protocol
Default File Server
FTP Directory
FTP User Name
FTP User Password
Routing Setup
OL-2159-03
Use the pull-down menu to select FTP or TFTP (Trivial File Transfer Protocol).
TFTP is a relatively slow, low-security protocol that requires no username or
password.
Enter the IP address or DNS name of the file server where the access point should
look for FTP files.
Enter the file server directory that contains the firmware image files.
Enter the username assigned to your FTP server. You don't need to enter a name
in this field if you select TFTP as the file transfer protocol.
Enter the password associated with the file server's username. You don't need to
enter a password in this field if you select TFTP as the file transfer protocol.
You use the Routing Setup page to configure the access point to communicate
with the IP network routing system. You use the page settings to specify the
default gateway and to build a list of installed network route settings.
shows the Routing Setup page.
Cisco Aironet 1200 Series Access Point Software Configuration Guide
Routing Setup
Figure 3-24
3-61