Resetting to the Default Configuration
Note
In the Connection Description window, enter a name and select an icon for the
Step 3
connection and click OK.
In the Connect To window, select the port to which the cable is connected and
Step 4
click OK.
In the Port Settings window, enter the following settings:
Step 5
•
•
•
•
•
Click OK, and press Enter.
Step 6
When the Summary Status screen appears, reboot the access point by unplugging
Step 7
the power connector and then plugging it back in.
When the access point reboots and the Summary Status screen reappears, type
Step 8
:resetall, and press Enter.
Type yes, and press Enter to confirm the command.
Step 9
The resetall command is valid for only 2 minutes immediately after the access
Note
point reboots. If you do not enter and confirm the resetall command during that 2
minutes, reboot the access point again.
After the access point reboots and the Express Setup screen appears, reconfigure
Step 10
the access point by using the terminal emulator or an Internet browser.
Cisco Aironet 1200 Series Access Point Software Configuration Guide
9-44
These instructions describe HyperTeminal; other programs are similar.
9600 baud,
8 data bits,
No parity,
1 stop bit, and
No flow control
Chapter 9
Diagnostics and Troubleshooting
OL-2159-03