Cisco AIR-LAP1252AG-A-K9 - Aironet 1252AG - Wireless Access Point Software Configuration Manual page 140

Setting Up EAP Authentication
Use the 802.1X Protocol Version (for EAP authentication) pull-down menu to
Step 2
select the draft of the 802.1X protocol the access point's radio will use. EAP
operates only when the radio firmware on client devices complies with the same
802.1X Protocol draft as the management firmware on the access point. If the
radio firmware on the client devices that will associate with the access point is
4.16, for example, you should select Draft 8. Menu options include:
•
•
•
Table 4-3
with which they comply.
Table 4-3
Firmware Version
PC/PCI cards 4.13
PC/PCI cards 4.16
PC/PCI cards 4.23
PC/PCI cards 4.25 and later
WGB34x/352 8.58
WGB34x/352 8.61 or later
AP34x/35x 11.05 and earlier
AP34x/35x 11.06 and later
BR352 11.06 and later
Cisco Aironet 1200 Series Access Point Software Configuration Guide
4-22
Draft 7—No radio firmware versions compliant with Draft 7 have LEAP
capability, so do not select this setting.
Draft 8—Select this option if LEAP-enabled client devices that associate
with this access point use radio firmware versions 4.13, 4.16, or 4.23.
Draft 10—Select this option if client devices that associate with this access
point use Microsoft Windows XP authentication or if LEAP-enabled client
devices that associate with this access point use radio firmware version 4.25
or later.
Functionality in Draft 10 is equivalent to the functionality in Draft 11,
Note
the ratified draft of the 802.1X standard.
lists radio firmware versions for Cisco Aironet products and the drafts
802.1x Protocol Drafts and Compliant Client Firmware
1
2
Chapter 4 Security Setup
Draft 7 Draft 8 Draft 10
— x
— x
— x
— —
— x
— —
— x
— x
— x
OL-2159-03
1
—
—
—
x
—
x
—
x
x