Settings On The Cdp Setup Page; Mib For Cdp - Cisco AIR-LAP1252AG-A-K9 - Aironet 1252AG - Wireless Access Point Software Configuration Manual

Using Cisco Discovery Protocol

Settings on the CDP Setup Page

MIB for CDP

Cisco Aironet 1200 Series Access Point Software Configuration Guide
5-14
The CDP Setup page contains the following settings:
Enabled/Disabled—Select Disabled to disable CDP on the access point;
•
select Enabled to enable CDP on the access point. CDP is enabled by default.
Packet hold time—The number of seconds other CDP-enabled devices should
•
consider the access point's CDP information valid. If other devices do not
receive another CDP packet from the access point before this time elapses
they should assume that the access point has gone offline. The default value
is 180. The packet hold time should always be greater than the value in the
"Packets sent every" field.
Packets sent every—The number of seconds between each CDP packet the
•
access point sends. The default value is 60. This value should always be less
than the packet hold time.
Individual Port Enable: Ethernet—When selected, the access point sends
•
CDP packets through its Ethernet port and monitors the Ethernet for CDP
packets from other devices.
Individual Port Enable: AP Radio Internal or AP Radio Module—This
•
checkbox appears when one of the access point radios is linked to another
radio infrastructure device, such as an access point or a bridge. When
selected, the access point sends CDP packets through the radio port and
monitors the radio for CDP packets from other devices.
A MIB file is available for use with CDP. The filename is CISCO-CDP-MIB.my,
and you can download the MIB at the following URL:
http://www.cisco.com/public/mibs
Chapter 5 Network Management
OL-2159-03