Using Command-Line Diagnostics - Cisco AIR-LAP1252AG-A-K9 - Aironet 1252AG - Wireless Access Point Software Configuration Manual

Using Command-Line Diagnostics

Using Command-Line Diagnostics
Cisco Aironet 1200 Series Access Point Software Configuration Guide
9-20
You can view diagnostic information about your access point with diagnostic
commands. Enter the commands in the command-line interface (CLI) to display
the information. You can open the CLI with Telnet or with a terminal emulator
through the access point's serial port.
Table 9-1 lists the access point's diagnostic commands. Click a command in the
left column to go to a description of that command's results.
Table 9-1 CLI Diagnostic Commands
Command
:eap_diag1_on
:eap_diag2_on
:vxdiag_arpshow
:vxdiag_checkstack
:vxdiag_hostshow
:vxdiag_i
:vxdiag_ipstatshow
:vxdiag_memshow
:vxdiag_muxshow
:vxdiag_routeshow
:vxdiag_tcpstatshow
:vxdiag_udpstatshow
Chapter 9
Information Displayed
authentication progress for client devices
authenticating through the access point
packet contents of each authentication step for client
devices authenticating through the access point
the ARP table
task stack on the access point
remote host list with IP addresses and aliases
task list on the access point
IP statistics
free and allocated memory on the access point
networking protocols installed on the access point
current routing information
TCP statistics
UDP statistics
Diagnostics and Troubleshooting
OL-2159-03