Chapter 9
Diagnostics and Troubleshooting
:vxdiag_memshow
:vxdiag_muxshow
Device: emac Unit: 0
Description: PPC405GP Ethernet Media Access Controller Enhanced Network Driver
Protocol: AWC Packet Router
Protocol: Cisco Discovery Protocol (CDP)
Shutdown 0x0
Protocol: AWC DDP Protocol
Protocol: IP 4.4 ARP
OL-2159-03
Use the :vxdiag_memshow command to display information on the access
point's free and allocated memory. The access point's current memory
information might look like the following example:
status
bytes
blocks
------ --------- -------- ---------- ----------
current
free
7386392
alloc
6738808
cumulative
alloc
13483152
These are descriptions for each information column:
Status—the memory statuses described in the table, including current free
•
memory, current allocated memory, and cumulative allocated memory, which
is the total bytes and blocks of memory ever allocated by the access point
bytes—the memory for each status described in bytes
•
blocks—the memory for each status described in contiguous blocks; indicates
•
the level of fragmentation in the access point's memory
avg block—the average block size; simply put, the number in the bytes
•
column divided by the number in the blocks column
max block—the maximum contiguous memory block available
•
Follow the steps in the
open the CLI and enter the :vxdiag_memshow command.
Use the :vxdiag_muxshow command to display all the networking protocols
installed on the access point. The list of installed protocols might look like the
following example:
Type: 2054
Cisco Aironet 1200 Series Access Point Software Configuration Guide
avg block
max block
476
15517
10837
621
126889
106
"Entering Diagnostic Commands" section on page 9-21
Type: 257
Recv 0x5ad0c
Type: 8192
Type: 34605
Recv 0x6986c
Recv 0x2732c
Using Command-Line Diagnostics
7296288
-
-
Shutdown 0x5fbd0
Recv 0x4f2c0
Shutdown 0x6a728
Shutdown 0x275ec
to
9-29