Settings On The Database Query Page; Changing Settings With The Database Query Page - Cisco AIR-LAP1252AG-A-K9 - Aironet 1252AG - Wireless Access Point Software Configuration Manual

SNMP Setup

Settings on the Database Query Page

Changing Settings with the Database Query Page

Step 1
Step 2
Step 3
Step 4
Note
Cisco Aironet 1200 Series Access Point Software Configuration Guide
7-4
The Database Query page contains the following entry fields and buttons:
OID—Type the object identifier (OID) in the OID field. You can use the
•
integer or ASCII version of the OID. If you use the integer version of the OID,
you must type the entire OID string (1.3.7.2.13.78.5.6, for example). If you
use the ASCII name, you can often use the object's name as specified in the
appropriate MIB (enableSNMP, for example).
Value—When you click Get, the object's value appears in the Value field. If
•
you want to assign a value to an object, you type an SNMP value in this field
and click Set.
Get—Click Get to find an object's value.
•
Set—Click Set to assign a value to an object.
•
Reset—Click Reset to return the page to default settings.
•
Follow these steps to change an access point setting from the Database Query
page:
Type the object identifier (OID) in the OID field. You can use the integer or ASCII
version of the OID. If you use the integer version of the OID, you must type the
entire OID string (1.3.7.2.13.78.5.6, for example). If you use the ASCII name,
you can often use the object's name as specified in the appropriate MIB
(enableSNMP, for example). MIBs supported by the access point are listed in the
"Supported MIBs" section on page
Click Get. The current value for the setting appears in the Value field.
Modify the value in the Value field.
Click Set. The new value is set on the access point.
If the object is read-only, the value is not changed when you click Set.
Chapter 7
2-10.
Management System Setup
OL-2159-03