Cisco AIR-LAP1252AG-A-K9 - Aironet 1252AG - Wireless Access Point Software Configuration Manual page 157

Chapter 4 Security Setup
Table 4-5 Settings for Authentication Types (continued)
Authentication Types
MAC-based
MAC-based and
EAP-TLS and EAP-MD5
MAC-based and LEAP
OL-2159-03
Required Settings
On the Address Filters page (shown in
Select yes for the "Look up MAC address on authentication server if
•
not in existing filter list" setting.
On the Authenticator Configuration page (shown in
Select an 802.1x protocol draft that matches the protocol draft used by
•
client devices that associate with the access point.
Enter the name or IP address, type, port, shared secret, and timeout
•
value for your RADIUS server.
Select the MAC Address Authentication checkbox under the server.
•
You can use the same server for both EAP authentication and
Note
MAC-based authentication.
On the AP Radio Advanced page for the internal radio or the radio module
(shown in Figure 4-12):
• Select Disallowed from the pull-down menu for Default Unicast
Address Filter for each authentication type requiring MAC-based
authentication.
Enter the settings for the EAP authentication types you need to support;
•
select Require EAP on the AP Radio Data Encryption page under
Open.
• Enter the settings for MAC-based authentication.
On the Address Filters page (shown in
Select yes for the setting called "Is MAC Authentication alone
•
sufficient for a client to be fully authenticated?"
Enter the settings for LEAP.
•
• Enter the settings for MAC-based authentication.
Cisco Aironet 1200 Series Access Point Software Configuration Guide
Summary of Settings for Authentication Types
Figure 4-10):
Figure
Figure 4-10):
4-13):
4-39