Using Hot Standby Mode
Figure 8-2
Follow this link path to reach the Hot Standby page:
•
•
•
Wireless client devices associated to the standby access point lose their
Note
connections during the hot standby setup process.
Follow these steps to enable Hot Standby mode:
On the standby access point, duplicate the settings that are entered on the
Step 1
monitored access point. Critical settings include:
•
•
•
•
•
•
Cisco Aironet 1200 Series Access Point Software Configuration Guide
8-6
Hot Standby Page
On the Summary Status page, click Setup.
On the Setup page, click Cisco Services under Services.
On the Cisco Services Setup page, click Hot Standby Management.
SSID (found on the Express Setup page)
Default IP Subnet Mask (also on the Express Setup page)
Default Gateway (also on the Express Setup page)
Data rates (found on the AP Radio Hardware page)
WEP settings (found on the AP Radio Data Encryption page)
Authentication Types (found on the AP Radio Data Encryption page)
Chapter 8
Special Configurations
OL-2159-03