Installing The Chassis Intrusion Detection Switch Option - HP HPE ProLiant DL365 Gen10 Plus Server User Manual

Installing the Chassis Intrusion Detection switch option

Installing the Chassis Intrusion Detection switch option
Prerequisites Prerequisites
Before installing this option, be sure you have the following:
The components included with the hardware option kit
Procedure Procedure
1. Power down the server (Power down the server).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
a. Extend the server from the rack ( Extend the server from the rack ).
b. Remove the server from the rack ( Remove the server from the rack ).
4. Remove the access panel ( Remove the access panel ).
5. Assemble the connector/cable harness pin openings to the alignment pegs on the DIMM guard.
6. Install the DIMM guard, and then connect the cable to the system board.
7. Install the access panel ( Install the access panel ).
8. Install the server in the rack.
9. Connect each power cord to the server.
10. Connect each power cord to the power source.
11. Power up the server (Power up the server ).
Installing the Chassis Intrusion Detection switch option 133