Domain Name Server; Domain Name Server Page - HP Integrity BL870c Operation Manual

NOTE: The BL c-Class tab is available only on HP Integrity server blades.
Table 8-29 lists the fields, buttons, and descriptions.
Table 8-29 Standard Page Description
Fields and Buttons
MAC Address
DHCP Status
iLO 2 MP Host Name
IP Address
Subnet Mask
Gateway Address
Link State
Submit
Cancel

Domain Name Server

The Domain Name Server (DNS) page
settings, domain name, and up to three DNS servers manually or automatically through DHCP.
It further enables a DDNS update through the primary DNS server as long as it is authoritative
for the zone. You must have iLO configuration access right to use this feature.
You can only configure the DNS server if DHCP is enabled.
NOTE:
Depending on your server, this page might look slightly different.
Figure 8-29 Domain Name Server Page
The 12 digit (hexadecimal) MAC address.
Enable or Disable.
The host name set here is displayed at the iLO 2 command interface prompt.
The iLO 2 MP IP address. If DHCP is being used, the IP address is automatically
supplied.
The subnet mask for the iLO 2 IP network. If DHCP is being used, the subnet mask is
automatically supplied.
The IP address of the network gateway. If DHCP is being used, the gateway IP address
is automatically supplied.
Auto Negotiate or 10 BaseT option.
Submits the information.
Cancels the action.
(Figure
Description
8-29) enables you to configure the DNS server
Web GUI 147