Configuration; Bmc; Web Gui Introduction; Ip Address - HP Cloudline CL2100 G3 806R User And Maintenance Manual

Configuration

BMC

Web GUI introduction

The web GUI is a friendly interface for the end users. A user can access the iBMC FW via a web browser,
and then go through the server status and do many configurations to the IBMC FW.
The default user privilege is set to administrator. The web function access rights are determined by different
privileges. For example, the administrator privilege can access all functions, but the user privilege cannot.
The web GUI provides many useful functions, such as:

firmware update

system power control

system event log (SEL)

current sensor reading

configuration for: BMC network, user accounts, serial, PEF, alerts, SOL, information about BMC, and
the system

IP address

Static and DHCP are the two common IP sources of iBMC FW. The default setting is DHCP. The detailed IP
address information is available from the BIOS setup menu.

User name and password

A user name and password are required to establish a web GUI session. The user should also have
accessibility to the LAN channel. Use the system management software to set the user name, password,
and grant access. The default setting is shown below:

ID 2: User Name = ADMIN

Web browsers

iBMC FW supports either Microsoft Internet Explorer (Windows platform) or Firefox (Linux platform).
The embedded web serve provides full access. The web GUI is accessible via the HTTP protocol or via the
encrypted HTTPS protocol.

Logging in

To log in to the web GUI, enter the iBMC FW IP address into a web browser. An example of using the
HTTP protocol is http://10.141.104.176. An example of using the encrypted HTTPS protocol is
https://10.141.104.176
Password = ADMIN
Configuration 60