Monitoring and Configuring the Printer
Getting Printer Information over the Network
This section explains details of each item displayed in the printer status and in-
formation.
This manual covers all models, and therefore contains functions and settings
that may not be available for your model.
2
Current Printer Status
The printer status can be checked using the following commands:
• UNIX: Use the "lpq" command and "rsh", "rcp", "ftp", and "sftp" parameters.
• mshell: Use the "status" command.
Messages
Access Restricted
Adjusting...
Call Service Center
Canceled
Canceling Job...
Cannot Eject Original Through
Card/Counter not inserted
Coin or amount not inserted
Coin/Key Counter not inserted The machine is waiting for coin or key counter.
Configuring...
Cooling Down Fusing Unit...
Cover Open: Finisher Cover
Data Size Error
Empty: Black Toner
Energy Saver Mode
Error
Error: Address Book
Error: Command Transmission
Error: DIMM Value
Error: Ethernet Board
Error: HDD Board
Error: Memory Switch
Error: Optional Font
Error: Parallel I/F Board
94
The job was canceled because user have no authority.
The machine is initializing or calibrating.
There is a malfunction in the machine.
The job is reset.
The job is being reset.
Cannot output prints to the Rear Paper Exit.
The machine is waiting for prepaid card or key.
The machine is waiting for coin to be inserted.
Setting is being changed.
The fusing unit is cooling down.
The cover of Finisher is open.
The data size error occurred.
The black toner cartridge is almost empty.
The machine is in Energy Save Mode.
An error has occurred.
An error has occurred in the data of the address book.
An error has occurred in the machine.
A memory error occurred.
An Ethernet board error has occurred.
A hard disk drive board error has occurred.
A memory switch error has occurred.
An error has occurred in the font file of the machine.
An error has occurred in the parallel interface.
Description