Authfree - Ricoh Aficio MP W3600 Network Manual

authfree

Use the "authfree" command to display and configure authentication exclusion
control settings.
❖ View Settings
msh> authfree
If print job authentication exclusion is not set, authentication exclusion control
cannot be displayed.
❖ IPv4 address settings
msh> authfree "ID" range_addr1 range_addr2
❖ IPv6 address settings
msh> authfree "ID" range6_addr1 range6_addr2
❖ IPv6 address mask settings
msh> authfree "ID" mask6_addr1 masklen
❖ Parallel/USB settings
msh> authfree [parallel|usb] [on|off]
To enable authfree, set to "on". To disable authfree, set to "off".
Always specify the interface.
❖ Authentication exclusion control initialization
msh> authfree flush
Note
❒ For IPv4 and IPv6, up to five access ranges can be registered and selected.
Remote Maintenance by telnet
2
63