Wiconfig - Ricoh Aficio MP W3600 Network Manual

wiconfig

Use the "wiconfig" command to make settings for IEEE 802.11b.
❖ View settings
msh> wiconfig
❖ View IEEE 802.11b settings
msh> wiconfig cardinfo
• If IEEE 802.11b is not working correctly, its information is not displayed.
❖ Configuration
msh> wiconfig "parameter"
Parameter
mode [ap|adhoc|802.11adhoc]
ssid "ID value"
channel frequency "channel no."
key [ "key value" ] val [1|2|3|4]
Value configured
You can set the infrastructure mode (ap), the 802.11 Ad
hoc mode (802.11adhoc), or the ad hoc mode (adhoc).
The default is ad hoc mode.
You can make settings for the SSID in the infrastruc-
ture mode.
Usable characters are ASCII 0x20-0x7e (32 bytes).
An SSID value is set automatically to the nearest ac-
cess point if no setting is made.
If no setting is made for the 802.11 ad hoc mode, the
same value as for the infrastructure mode or an ASSID
value is automatically set. The default is blank.
You can enable or disable the WEP function. To enable
the WEP function, specify [on]; to disable it, specify [off].
To start the WEP function, enter the correct WEP key.
The default is "11".
You can specify the WEP key when entering in hexa-
decimal.
With a 64-bit WEP, you can use 10 digit hexadecimals.
With a 128-bit WEP, you can use 26 digit hexadecimals.
Up to four WEP keys can be registered. Specify the
number to be registered with "val".
When a WEP is specified by key, the WEP specified by
key phrase is overwritten.
To use this function, set the same key number and
WEP key for all ports that transmit data to each other.
Put "0x"on the front of WEP key.
You can omit the numbers with "val". The key
number is set to 1 when making these omissions. The
default is blank.
Remote Maintenance by telnet
2
89