Registering The Utm With Netgear - NETGEAR UTM25-100NAS - Prosecure Utm Appliance 25U No Sub Included Reference Manual

Prosecure unified threat management
Table of Contents

Advertisement

ProSecure Unified Threat Management UTM10 or UTM25 Reference Manual
Verify that the UTM properly scans HTTP traffic:
1. Log on to the UTM Web Management Interface, and then verify that HTTP scanning is
enabled. For information about how to enable HTTP scanning, see
Protocol Scan Settings and Services" on page 6-19
page
6-21.
2. Check the downloaded eicar.com test file, and note the attached malware information file.

Registering the UTM with NETGEAR

To receive threat management component updates and technical support, you must register your
UTM with NETGEAR. The support registration key is provided with the product package (see
"Service Registration Card with License Keys" on page
Note: Activating the service licenses initiates their terms of use. Activate the licenses
only when you are ready to start using this unit. If your unit has never been
registered before you can use the 30-day trial period for all 3 types of licenses to
perform the initial testing and configuration. To use the trial period, do not click
Register in
Using the Setup Wizard to Provision the UTM in Your Network
step 4
of the procedure below but click Trial instead.
v1.0, September 2009
"Customizing Web
and
"Configuring Web Malware Scans" on
1-8).
2-27

Advertisement

Table of Contents
loading

This manual is also suitable for:

Prosecure utm10Prosecure utm25

Table of Contents