Managing Routing - NETGEAR UTM25-100NAS - Prosecure Utm Appliance 25U No Sub Included Reference Manual

ProSecure Unified Threat Management UTM10 or UTM25 Reference Manual
Table 4-3. DMZ Setup Settings (continued)
Setting
DNS Proxy
Enable DNS Proxy
3. Click Apply to save your settings.
Note: The DMZ LED next to LAN port 4 (see
green to indicate that the DMZ port is enabled.
To define the DMZ WAN Rules and LAN DMZ Rules, see
page 5-14 and "Setting LAN DMZ Rules" on page

Managing Routing

Static Routes provide additional routing information to your UTM. Under normal circumstances,
the has adequate routing information after it has been configured for Internet access, and you do
not need to configure additional static routes. You should configure static routes only for unusual
cases such as multiple firewalls or multiple IP subnets located on your network.
Note: The automatically sets up routes between VLANs and secondary IP addresses that
you have configured on the LAN Multi-homing screen (see
Home LAN IPs on the Default VLAN" on page
to manually add a static route between a VLAN and a secondary IP address.
4-22
Description (or Subfield and Description)
This is optional. Select the Enable DNS Proxy radio button to enable the UTM
to provide a LAN IP address for DNS address name resolution. This setting is
enabled by default.
Note: The UTM still services DNS requests sent to its LAN IP address unless
you disable DNS Proxy in the firewall settings (see
page 5-20).
v1.0, September 2009
"Attack Checks" on
"Front Panel" on page
"Setting DMZ WAN Rules" on
5-18, respectively.
"Configuring Multi-
4-11). Therefore, you do not need
1-9) lights
LAN Configuration