Configuring The Prosafe Vpn Client For Mode Config Operation - NETGEAR UTM25-100NAS - Prosecure Utm Appliance 25U No Sub Included Reference Manual

ProSecure Unified Threat Management UTM10 or UTM25 Reference Manual
Table 7-16. Add IKE Policy Settings for a Mode Config Configuration (continued)
Item
Extended Authentication
XAUTH Configuration
Note: For more
information about
XAUTH and its
authentication modes,
see "Configuring
XAUTH for VPN
Clients" on page 7-38.
9. Click Apply to save your settings. The IKE policy is added to the List of IKE Policies table.

Configuring the ProSafe VPN Client for Mode Config Operation

From a client PC running NETGEAR ProSafe VPN Client software, configure the remote VPN
client connection for Mode Config operation:
1. Right-click on the VPN client icon in your Windows toolbar, select Security Policy Editor.
Then, select Options > Secure, and verify that the Specified Connections selection is enabled
(see Figure 7-11 on page
Virtual Private Networking Using IPsec Connections
Description (or Subfield and Description)
Select one of the following radio buttons to specify whether or not Extended
Authentication (XAUTH) is enabled, and–if enabled–which device is used to
verify user account information:
• None. XAUTH is disabled. This the default setting.
• Edge Device. The UTM functions as a VPN concentrator on which one or
more gateway tunnels terminate. The authentication mode that is available
for this configuration is User Database, RADIUS PAP, or RADIUS CHAP.
• IPSec Host. The UTM functions as a VPN client of the remote gateway. In
this configuration the UTM is authenticated by a remote gateway with a user
name and password combination.
Authentication For an Edge Device configuration: from the pull-down
Type menu, select one of the following authentication types:
• User Database. XAUTH occurs through the UTM's user
database. Users must be added through the Add User
screen (see
page
• Radius PAP. XAUTH occurs through RADIUS Password
Authentication Protocol (PAP). The local user database is
first checked. If the user account is not present in the
local user database, the UTM25 connects to a RADIUS
server. For more information, see
Configuration" on page
• Radius CHAP. XAUTH occurs through RADIUS
Challenge Handshake Authentication Protocol (CHAP).
For more information, see
on page
Username The user name for XAUTH.
Password The password for XAUTH.
7-12).
v1.0, September 2009
"User Database Configuration" on
7-39).
7-39.
"RADIUS Client Configuration"
7-39.
"RADIUS Client
7-49