Viewing Attached Devices And The Dhcp Log - NETGEAR UTM25-100NAS - Prosecure Utm Appliance 25U No Sub Included Reference Manual

ProSecure Unified Threat Management UTM10 or UTM25 Reference Manual
The Connection Status screen displays the information that is described in
Table 11-14. WAN1 (UTM25) or WAN (UTM10) Port Status Informations
Item
Connection Time
Connection Type
Connection Status
IP Address
Subnet Mask
Gateway
DNS Server
DHCP Server
Lease Obtained
Lease Duration
Depending on the type of connections, any of the following buttons may be displayed on the
Connection Status screen:
• renew. Click to renew the DHCP lease.
• release. Click to disconnect the DHCP connection.
• disconnect. Click to disconnect the static IP connection.
For the UTM25 only, the procedure to view the status of the WAN2 port is identical to the one for
the WAN1 port with the exception that you must select the WAN2 ISP Settings submenu tab to
display the WAN2 ISP Setting screen.

Viewing Attached Devices and the DHCP Log

The LAN Groups screen contains a table of all IP devices that the UTM has discovered on the
local network. The LAN Setup screen lets you access the DHCP log.
Viewing Attached Devices
To view the attached devices in the LAN Groups screen:
1. Select Network Config > LAN Settings from the menu. The LAN Settings submenu tabs
appear, with the LAN Setup screen in view (see
some profiles in the VLAN Profiles table as an example).
Monitoring System Access and Performance
Description (or Subfield and Description)
The period that the UTM has been connected through the WAN port.
DHCP or Static IP.
Connected or Disconnected.
The addresses that were automatically detected (see
and Connecting" on page
screen (UTM25) or WAN ISP Settings screen (UTM10) (see
Configuring the Internet Connection" on page
The DHCP server that was automatically detected (see
and Connecting" on page
Edit VLAN Profile screen (see
The time when the DHCP lease was obtained.
The period that the DHCP lease remains in effect.
v1.0, September 2009
3-2) or that you configured on the WAN1 ISP Settings
3-5).
3-2) or that you configured for a VLAN profile on the
"Configuring a VLAN Profile" on page
Figure 11-20 on page
Table 11-14.
"Automatically Detecting
"Manually
"Automatically Detecting
4-6).
11-30, which contains
11-29