Figure 15 Removing
Mounting Brackets
(Left Side Shown)
ValueLoader DLT VS80/DLT VS160 Tape Autoloader User Manual
Remove the power cable and SCSI cables from their connectors
2
on the back panel of the ValueLoader.
To prevent injury, disconnect the power and SCSI
Warning:
cables before removing the ValueLoader cover
and keep fingers away from the fan.
Remove the ValueLoader from its rack slot, if applicable, and
3
place it on a table or other clear work surface.
Use a screwdriver to remove the front cover screws that secure
4
the mounting brackets (if the ValueLoader is rackmounted)
from both sides of the ValueLoader, as shown in
Remove the five screws on the back of the ValueLoader, and
5
two additional screws, one on each side of the ValueLoader, to
loosen the ValueLoader cover.
Remove the top cover by lifting it from the back and easing it
6
out from under the front panel display cover.
Diagnostics and Troubleshooting
Removing Stuck Cartridges
figure
15.
59