Creating An Inventory Of Cartridges - Freecom VALUELOADER DLT User Manual

Operating the ValueLoader

Creating an Inventory of Cartridges

Creating an Inventory of Cartridges

36 ValueLoader DLT VS80/DLT VS160 Tape Autoloader User Manual
During the cleaning process, which can take several minutes,
the LCD screen displays "Drive Cleaning".
If the cartridge is not a valid cleaning cartridge, the
Note:
LCD screen will display "Bad clean tape" and the
cartridge will be exported.
When tape drive cleaning is complete, the Clean Drive LED
6
turns off (if previously on) and the ValueLoader unloads and
exports the cleaning cartridge. Remove the cleaning cartridge,
and press the
[Enter]
to do so.
If the Clean Drive or Media Attention LED is
Note:
illuminated again when you insert another cartridge
immediately after cleaning, see
troubleshoot.
If you had to remove a data cartridge to import the cleaning
7
cartridge, import that data cartridge to its original slot. See
Importing Cartridges
This option builds a new inventory of cartridges in the
ValueLoader. If using a barcode reader, this option also scans the
barcode labels on each cartridge in the carousel. (See
Reader on page 3 for more information.) To use this option, follow
these steps:
From the Home screen or main menu, press the
1
until "Commands" appears on the top line of the LCD screen.
Press the
2 [Enter]
Press the or
3 [+] [–]
LCD screen. Press
button when the LCD screen prompts you
on page 28 for more information.
button to access the available options.
button until "Re-inventory" appears on the
.
[Enter]
table 4 on page 52 to
Barcode
or button
[+] [–]
2