Installing A Power Supply - Dell PowerEdge E06S Series Hardware Owner's Manual

Figure 3-32. Removing and Installing a Power Supply
1 power supply
3 cable retention bracket

Installing a Power Supply

1 Verify that power supplies are the same type and have the same maximum
output power.
NOTE:
supply label.
2 If applicable, remove the power supply blank. See "Removing the Power
Supply Blank" on page 157.
3 Slide the new power supply into the chassis until the power supply is fully
seated and the release latch snaps into place. See Figure 3-32.
NOTE:
procedure, relatch it. For information about the cable management arm, see
the system's rack documentation.
4 Connect the power cable to the power supply and plug the cable into a
power outlet.
156
Installing System Components
The maximum output power (shown in watts) is listed on the power
If you unlatched the cable management arm in step of the previous
1
2 locking tab
2
3