Removing The Power Supply Blank; Installing The Power Supply Blank; System Battery; Replacing The System Battery - Dell PowerEdge E06S Series Hardware Owner's Manual

CAUTION:
When connecting the power cable, secure the cable with the Velcro
strap.
NOTE:
When installing, hot-swapping, or hot-adding a new power supply in a
system, allow several seconds for the system to recognize the power supply and
determine its status. The power-supply status indicator turns green to signify that
the power supply is functioning properly.

Removing the Power Supply Blank

If you are installing a power supply, remove the power supply blank by pulling
outward on the blank.
CAUTION:
To ensure proper system cooling, the power supply blank must be
installed in each power supply bay that does not have a power supply. Remove the
power supply blank only if you are installing an additional power supply.

Installing the Power Supply Blank

NOTE:
Install the power supply blank only in power supply bays 2, 3, or 4.
To install the power supply blank, align the blank with the power supply bay
and insert the blank into the chassis until it clicks into place.

System Battery

Replacing the System Battery

WARNING:
installed. Replace the battery only with the same or equivalent type recommended
by the manufacturer. See your safety information for additional information.
CAUTION:
Many repairs may only be done by a certified service technician.
You should only perform troubleshooting and simple repairs as authorized in
your product documentation, or as directed by the online or telephone service
and support team. Damage due to servicing that is not authorized by Dell is not
covered by your warranty. Read and follow the safety instructions that came
with the product.
1 Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet.
2 Open the system. See "Opening the System" on page 89.
There is a danger of a new battery exploding if it is incorrectly
Installing System Components
157