Dell PowerEdge E06S Series Hardware Owner's Manual page 158

Figure 3-33. Replacing the System Battery
1 positive side of battery connector
3 negative side of battery connector
3 Locate the battery socket. See "System Board Connectors" on page 198.
CAUTION:
connector while installing or removing a battery.
4 To remove the battery, support the battery connector by pressing down
firmly on the positive side of the connector.
5 Press the battery toward the positive side of the connector and lift it up out
of the securing tabs at the negative side of the connector.
6 To install a new system battery, support the battery connector by pressing
down firmly on the positive side of the connector.
7 Hold the battery with the "+" facing up and slide it under the securing
tabs at the positive side of the connector.
8 Press the battery straight down into the connector until it snaps into place.
9 Close the system. See "Closing the System" on page 90.
10 Reconnect the system to the electrical outlet and turn the system on,
including any attached peripherals.
158
Installing System Components
1
To avoid damage to the battery connector, you must firmly support the
2
3
2 system battery