Serial Communication Screen - Dell PowerEdge E06S Series Hardware Owner's Manual

Serial Communication Screen

Option
Serial Communication
(On without Console
Redirection default)
Serial Port Address
(Serial Device 1=COM1,
Serial Device2=COM2
default)
External Serial Connector
Failsafe Baud Rate
(115200 default)
Remote Terminal Type
(VT 100/VT220 default)
Redirection After Boot
(Enabled default)
72
Using the System Setup Program and UEFI Boot Manager
Description
Selects whether the serial communication devices
(Serial Device 1 and Serial Device 2) are enabled in
BIOS. BIOS console redirection can also be enabled and
the port address used can be specified.
Options are On without Console Redirection, On with
Console Redirection via COM1, On with Console
Redirection via COM2, and Off.
Sets the serial port addresses for the two serial devices.
NOTE:
Only Serial Device 2 can be used for Serial Over
LAN (SOL). To use console redirection by SOL, configure
the same port address for console redirection and the
serial device.
Specifies whether Serial Device 1, Serial Device 2, or
Remote Access Device has access to the external serial
connector.
NOTE:
Only Serial Device 2 can be used for Serial Over
LAN (SOL). To use console redirection by SOL, configure
the same port address for console redirection and the
serial device.
Displays the failsafe baud rate used for console
redirection. BIOS attempts to determine the baud rate
automatically. This failsafe baud rate is used only if the
attempt fails. This rate should not be adjusted.
Sets the remote console terminal type, either
VT100/VT220 or ANSI.
Enables or disables BIOS console redirection when the
operating system is loaded.