Steps
1. Using a Phillips #2 screwdriver, remove the screw securing the PSU to the system.
2. Slide the PSU out of the PSU bay in the chassis.
Figure 69. Removing the cabled power supply unit
Next steps
Replace the
PSU.
Installing a power supply unit
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the air
shroud.
4. Remove the
expansion card
Steps
1. Slide the new PSU into the PSU bay in the chassis until the PSU is fully seated.
2. Using a Phillips #2 screwdriver, replace the screw to secure the PSU to the system.
72
Installing and removing system components
Safety
instructions.
Before working inside your
riser.
system.